-srvx Frequently Asked Questions
+X3 Frequently Asked Questions
-------------------------------
This FAQ assumes that your services are named NickServ, ChanServ and
OpServ respectively.
-Q1) How do I set up srvx?
+Q1) How do I set up X3?
A1) Read the README and INSTALL files, especially INSTALL.
-Q2) How do I set up my IRC server so srvx talks to it?
+Q2) How do I set up my IRC server so X3 talks to it?
A2) That depends on which IRC server you use. Check its
-documentation. #srvx WILL NOT SUPPORT YOUR IRCD QUESTIONS.
+documentation. #evilnet will not support ircd questions other
+than Nefarious IRCu
Q3) I get "You must first authenticate with NickServ", help!
A3) To register an account, /msg NickServ@services.example.com
register YourName Password. You must be a global IRC operator to
-register the first account; srvx gives the first account "root" level
+register the first account; X3 gives the first account "root" level
(1000) access. To log in afterwards, use the "auth" command instead
of "register".
Q5) When I try to register a channel with ChanServ, it tells me I have
to have "security override" on. Why?
-A5-1) srvx's default configuration is to only allow network staff to
+A5-1) X3's default configuration is to only allow network staff to
register channels. For IRC operators and network helpers (users with
account flag +H), security override can be enabled by sending "/msg
ChanServ god on". For support helpers (users with account flag +h),
Q6) How do I enable HelpServ?
A6) When you run the "configure" script, you must enable the helpserv
module; for example, "./configure --enable-modules=helpserv". After
-you compile and start srvx with that option, "/msg OpServ bind OpServ
+you compile and start X3 with that option, "/msg OpServ bind OpServ
helpserv *helpserv.helpserv". After that, you can use "/msg OpServ
helpserv help" and "/msg OpServ helpserv register"; the "helpserv"
command acts as a gateway into the HelpServ system.
module; for example, "./configure --enable-modules=memoserv". Then
see the comment near the start of src/mod-memoserv.c for configuration
options.
+
+Q8) How do I enable both HelpServ and MemoServ?
+A8) In addition to the post-install configuration steps above, you
+must mention both when you run the configure script. For example, run
+it using "./configure --enable-modules=memoserv,helpserv". (You may
+add the snoop and/or sockcheck modules as well; separate the module
+names with commas.)